Stainless steel fabrication in Utah

Stainless steel for the surfaces that get touched, bumped and cleaned the most: counter fronts, kick plates, corner guards, trims and small frames, made in our shop with a consistent brushed finish.

Gloved hand wiping a long brushed stainless counter front panel with folded edges on a padded workbench

Where stainless earns its place

Stainless steel is the material people choose when a surface has to look good after years of daily cleaning. In restaurants, cafes, shops and offices it shows up as the front of a service counter, the kick plate along the base of a bar, the corner guard on a busy wall, the trim around a pass through or the small shelf above a prep area.

Those parts need a finish that matches from piece to piece, edges that are safe to touch and corners that are tidy. That is where most of our time goes on a stainless job.

What we make

Counter front panels with folded returns, kick plates and base trims, corner guards in single lengths or with welded caps, edge trims and reveals, small shelves and brackets, covers and access panels, and frames for displays. Each part is cut, formed and finished in our shop, then wrapped and packed for your team.

Keeping the brushed finish even

Brushed stainless shows the direction of its grain. We plan the parts so the grain runs the same way across a set, keep the factory film on as long as the work allows and blend any welded corner back into the surrounding grain. Before the run, we send a photo of the first piece or have it ready to collect, so you can check it against your other materials.

Care notes we pass on

Brushed stainless keeps its even look when it is cleaned along the grain with a soft cloth and a mild cleaner, then wiped dry. Abrasive pads and harsh cleaners scratch the surface and dull the finish. We include a short care note with every stainless order, so the people who look after the counter or the service area know how to keep it even. If your parts sit next to raw steel during fitting, keep them covered, because steel dust can leave small rust spots on stainless that are easy to avoid and tedious to remove.

Working with your drawings

Send the elevation and section drawings, the thickness and finish you have in mind, and the quantity. If the drawing is still at the design stage, we are happy to comment on edge details, panel splits and how a part will be fixed, so the design suits the way stainless is formed.

What people ask about stainless steel fabrication

Which stainless finish do you supply?

Most of our stainless work is a satin brushed finish. If your design calls for something else, tell us and we talk through what is possible for the part.

Can welded corners match the brushed finish?

Yes. We blend welded corners back into the grain so they read as part of the same surface. A photo of the first corner is part of the approval step.

Are folded edges safe to touch?

We hem or return exposed edges on parts people touch and deburr every cut edge before the part leaves the shop.

Do you work with food service designers?

Yes. We make the panels, trims and small parts from their drawings, and they handle the overall layout of the space.

Need stainless steel fabrication?

Send the drawing, sketch or photo with the material and quantity. We reply with our questions and a written quote.