Architectural metal fabrication in Utah

Edge trims, reveal strips, frame profiles and corner pieces, cut and formed in our shop to the lines on your drawing, then packed and handed over ready for your team.

Long brushed aluminum edge trims, a blackened steel channel and a stainless reveal strip laid side by side on a felt mat

What this covers

Architectural metal, the way we use the term, is the thin line work that finishes an interior: the angle that protects the edge of a wall panel, the channel that frames a sheet of glass in a display, the slim reveal that separates two materials on a reception counter, the corner piece that turns a long trim around a tall bay of shelving. These are small parts in section, often long in length, and they are seen up close every day by the people who walk past them.

We make them from aluminum, stainless steel and mild steel sheet, cut to width, formed on the press brake and cut to length. Ends can be left square, mitered for a corner, notched to pass another part, or closed with a small welded or folded cap. Holes for fixings can be drilled or left off, depending on how your team plans to fix the piece.

Who sends us this work

Interior designers and architectural studios send us trim details from a set of drawings. Shopfitters and joinery workshops send profiles that need to meet their own panels and counters. Retail, restaurant and office teams send a photo of an existing trim they want matched, and display builders send cross sections for frames that hold graphics, glass or panels.

Most jobs are a few dozen meters of one or two profiles, plus a handful of corners and end pieces. Some are one long run of a single trim. Both are normal for us.

How we work through a trim job

We read the section first. A trim that looks simple on a drawing still has choices hidden in it: which face is the show face, which way the bends open, how tight the inside radius can be for the material and thickness, and where a long length has to be joined. We write those questions down and send them back with the quote, so the answers are settled before any sheet is cut.

Before a full run, we form a short first piece and send a photo or have it ready to collect, so you can hold it against your panel or sample. Once you approve it, the rest of the run is formed to match, protected with film where the finish needs it, bundled by length and labeled by the names on your drawing.

Finishes we prepare

Aluminum and stainless trims are usually supplied with a brushed or satin finish that runs along the length, which hides small marks and reads well under shop lighting. Mild steel trims can be left raw for a finisher, cleaned and sealed, or given a dark blackened look. If the parts go to a painter or powder coater after us, we prepare the edges and surfaces for that and tell you what to pass on to them.

What people ask about architectural metal fabrication

Can you match a trim we already have?

Usually, yes. Send a clear photo of the end of the trim with a ruler beside it, or a short offcut. We measure the section, draw it up and send the sketch back with the quote so you can confirm it.

How long can a single trim be?

That depends on the press brake length and on handling a long, thin part without marking it. We tell you the longest length we can form for your profile in the quote, and where a joint would sit if your run is longer.

Do you supply fixings?

We can drill or countersink holes to suit the fixings your team uses, and we can add small tabs or cleats on the back of a trim. The fixing method itself is your team's choice, and we build the part around it.

Can corners be made as one piece?

Many can. Outside and inside corners can be welded from mitered lengths and dressed smooth, or folded from one blank for some profiles. We suggest the cleanest option for your material and finish.

Need architectural metal fabrication?

Send the drawing, sketch or photo with the material and quantity. We reply with our questions and a written quote.