Metal bending services in Utah

Clean, repeatable bends in aluminum, stainless and mild steel sheet. Send a cross section or a flat blank and we form it on the press brake, one piece or a full run.

Gloved hands holding a long brushed aluminum strip against a press brake back gauge with a fresh fold along part of it

Bending as its own service

Some customers come to us for a finished trim or panel. Others already have the design worked out and simply need a shop that can put accurate bends in sheet metal. That second group includes fabricators who cut their own blanks, makers of displays and fixtures, product teams with a sheet part, and workshops that do not keep a press brake of their own.

We take flat blanks you send, or we cut the blanks for you from your drawing. Then we bend them in the order that keeps each flange reachable and each face clean, and we check the angles and flange lengths against your drawing as the run goes.

Shapes we form every week

Simple angles and L shapes, U channels and C channels with returns, Z shapes that step a panel off a wall, hat sections, closed hems and open hems that turn a raw edge into a safe rounded one, and boxed corners for small covers. Most sections combine two to four bends, which is exactly what the profile builder on our home page lets you sketch.

Where a part has many bends, we work out the bend order on paper first. A few shapes cannot be formed in one piece because a flange would hit the tooling, and in those cases we suggest a small change or a two piece version that joins cleanly.

What we need from you

A drawing with the cross section, the inside or outside dimensions clearly marked, the material and thickness, the length of each piece and the quantity. If a finish face matters, mark which side is seen. If you only have a sketch or a sample, send it anyway. We redraw it and send the sketch back for you to confirm before we quote the run.

Bend tolerances depend on material, thickness and length, so we confirm them in writing in the quote for your part rather than quoting a number in general.

Protecting the face of the part

Brushed and polished sheet arrives with a protective film, and we keep that film on through bending wherever we can. For parts that will be seen at close range, we use clean tooling and pads so the bend line stays crisp and the face stays free of tooling marks. Parts are stacked with spacers and packed so they reach you in the condition they left the brake.

What people ask about metal bending services

Can you bend parts we cut ourselves?

Yes. Send the blanks with a drawing that shows the bend lines and directions. We look them over when they arrive and tell you if any blank needs a change before bending.

What is the tightest bend you can make?

The inside radius depends on the material and thickness. Softer aluminum can go tighter than stainless. We tell you the radius we can hold for your part in the quote.

Do you bend thick plate?

Our work is mostly sheet and light plate for interior, display and product parts. Send the drawing and we tell you straight away whether the part suits our press brake.

Can you do one part only?

Yes. A single bent part, a short set of samples or a run of a few hundred are all normal jobs here.

Need metal bending services?

Send the drawing, sketch or photo with the material and quantity. We reply with our questions and a written quote.