Metal profiles and trims made in Utah
The long, thin lines of an interior: angles, channels, reveals and hemmed edges, formed on the press brake and cut to length in our shop.

Lines that protect, frame and finish
Profiles and trims are the lines of a room. They protect edges, frame panels, hide joints and draw a quiet outline around counters, displays and openings. In section they are small, often only a few centimeters across, but they run for meters and they are seen up close, so the quality of every bend and every end shows.
Our two services in this group cover the whole range. Architectural metal fabrication is for finished trims, reveals and frame profiles made to your drawing, with mitered corners, end caps and holes ready for fixing. Metal bending services are for customers who need accurate press brake bends in their own blanks or in blanks we cut for them.
-

Architectural metal fabrication
Edge trims, reveal strips, frame profiles and corner pieces, cut and formed in our shop to the lines on your drawing, then packed and handed over ready for your team.
Architectural metal fabrication in Utah -

Metal bending services
Clean, repeatable bends in aluminum, stainless and mild steel sheet. Send a cross section or a flat blank and we form it on the press brake, one piece or a full run.
Metal bending services in Utah
Six sections we form most
Drawn as cross sections, the way they appear on a drawing. You can sketch any of them with the profile builder on our home page.
Angle
One bend. The everyday edge trim for wall panels, counters, shelves and the ends of displays.
Channel
Two bends the same way. Frames the edge of a panel, glass or acrylic sheet.
Z profile
Two bends in opposite directions. Steps one surface off another, or hangs a panel on a cleat.
Reveal
A shallow channel set between two materials to leave a crisp shadow line.
Hat section
Four bends that stand a surface off the wall on two flanges.
Hemmed edge
A tight fold back on itself that turns a raw edge into a smooth, safe one.
Lengths, joints and corners
Long trims are formed in the longest lengths our press brake and the material allow. When your run is longer, we plan the joints with you so they fall at a natural break such as a panel joint or a corner. Corners can be mitered and welded, folded from a single blank for some shapes, or left as separate lengths with a small cover piece.
We list every length, joint and corner in the quote, so your team knows exactly what will arrive.
Material and thickness
Thin aluminum and stainless are the most common choices for interior trims. A thicker sheet gives a sturdier edge and a cleaner bend line on a wide flange, while a thinner sheet keeps the profile light and can form tighter radii. We suggest a thickness for your section and confirm the bend radius we can hold in writing.
Send us the section
A sketch of the cross section, the lengths and the quantity is enough to start. We answer with questions and a written quote.