Why aluminum suits line work
Aluminum is the material most of our trims and display frames are made from. It is light, so a long trim does not sag on the way to the wall. It forms well on the press brake, so crisp angles and channels come out clean. And it takes a brushed finish that reads as quiet and precise in a light interior.
We work with aluminum sheet, flat bar, angle, channel and square tube. Sheet is cut and bent into custom sections, while bar and extrusions are cut to length, mitered, drilled and joined into frames.
What we make from it
Edge trims and reveal strips for wall panels, frames that hold graphics, fabric or acrylic in displays, light panel backs and covers, shelf edges and brackets for display fixtures, small enclosures for product teams and sample pieces for designers who want to see a profile in their hand before they commit to it.
Cutting, forming and joining
Extrusions and bar are cut on the band saw and the ends are cleaned and deburred. Sheet is cut to blanks and bent on the press brake. Where parts need joining, we weld aluminum frames and dress the joints, or we plan a mechanical joint with fixings where a weld would mark a show face. We talk through the joint choice with you when we review the drawing.
Planning an aluminum job with us
Send the drawing or sketch with the alloy if you have one in mind, the thickness or extrusion size, the finish and the quantity. If the parts are a first set for a new display or product, tell us how many you expect to need later as well. That helps us choose a way of cutting and bending that stays consistent when you come back for a repeat run, and lets us keep the setup notes for your parts on file.
Small prototype sets and one-off samples are welcome. Many designers order two or three short lengths first, hold them against their materials, and then confirm the full run.
Finishes on aluminum
Most aluminum we supply is brushed along the length, which hides fine marks and keeps the surface consistent. Parts that will be anodized or powder coated by your finisher are prepared with clean edges and no film residue, and we can pack them in sets that match the finisher's racks if you tell us how they work.
What people ask about aluminum fabrication
Can you weld aluminum frames?
Yes. Small frames for displays and fixtures are welded and the joints dressed smooth. For frames with a show face, we may suggest a hidden joint instead.
Do you anodize?
We prepare parts for anodizing or powder coating and pack them for your finisher. The coating itself is done by the finisher you choose.
Which aluminum should we specify?
Tell us what the part does and how it is finished. We suggest a grade and temper that bends cleanly and finishes well, and confirm it in the quote.
Can you match an existing extrusion?
Often we can make a bent sheet profile that matches the look of an extrusion for a short run. Send a photo of the end of the profile with a ruler beside it.


