Metal panels and sheets made in Utah

The broad surfaces of metal in a room: counter fronts, wall sheets and display backs, cut, edged and folded in our shop to your layout.

Stack of brushed metal panels with folded edges on a padded rack

Flat, even and finished alike

Panels and sheets are the broad surfaces of metal in a room: the brushed front of a counter, a stainless sheet behind a service area, a set of aluminum backs for a display wall. They are about flatness, edges and a finish that looks the same from the first panel to the last.

This group brings together three services. Metal panels manufacturing covers the panels themselves, cut and edged to your layout. Aluminum fabrication and stainless steel fabrication go deeper into the two materials most of our panels are made from, and the trims, frames and small parts that go with them.

Four ways to finish a panel edge

The edge decides how a panel meets the wall, the counter or the next panel. Mark the one you want on your drawing, or ask us to suggest one.

  • Flat cut

    The sheet is cut and deburred. Suits panels set into a frame or behind a trim.

  • Single return

    One fold at the edge gives the panel depth and hides the cut.

  • Double return

    Two folds make a deeper, stiffer edge that can hook over a cleat.

  • Hem

    A tight fold back for edges people touch, such as the top of a counter front.

How a panel set is planned

We start from your elevation, work out how the panels divide across the sheet sizes for the material, and keep the brushed grain running the same way across the set. Openings for outlets, vents and hardware are cut in the shop before the edges are formed. The panel layout goes back to you with the quote, and each panel is marked with its reference from your drawing.

If a large panel needs help to stay flat, we suggest a return, a stiffening fold or a back tab and show it on the layout.

Choosing between aluminum and stainless

Aluminum keeps large panels light and is easy to handle on a ladder. Stainless suits surfaces that are cleaned often and bumped by carts, bags and shoes. Mild steel is a good base for painted or dark finishes. If you are not sure, tell us where the panel goes and how it is used, and we suggest the material that fits.

Send us the layout

An elevation with panel sizes, the edge detail and the finish is enough to start. We send the panel split back with the quote.