A drawing checklist for metal parts in Utah

Everything we look for on a drawing for a trim, a panel or an accent piece. Tick through it before you send a request.

Simple cross section sketch on paper with a matching bent aluminum profile, a tape measure, a pencil and a square

Why a good drawing helps

A good drawing is the fastest way to an accurate quote. It does not need to be a full drawing set. A clear section with a few dimensions, a note on the material and a quantity is often enough for us to quote a trim or a panel and to ask the right questions.

Use this list before you send a request. Tick each item as you go. Nothing is saved, it is simply a way to check you have covered the points we will ask about. If something is still undecided, leave it open and tell us. We are used to helping finish the details.

The shape

Material and finish

Lengths, ends and quantity

Holes, tabs and fixing

Handover

Sending files and photos

After you send the request form, reply to our email with your drawings attached. PDF drawings are easiest to read. Sketches photographed in good light work well too, as long as the dimensions are legible. For a trim you want matched, photograph the cut end straight on with a ruler beside it, and a second photo along the length to show the finish.

If you have a physical sample, you are welcome to drop it at the shop during office hours. We will measure it and return it with the parts.

What happens after we receive it

We read the drawing, check the bend order and the sheet layout, and write down any questions. Then we send a written quote with those questions, the lengths and quantities we have assumed, and the first piece step. Nothing is cut until you approve the quote and the details are settled.

Checklist done?

Send the request form, then reply to our email with the drawings attached. We read them and send back a written quote.